Temperature evolution in a WC-6% Co cutting tool during turning machining : experiment and finite element simulations

Abstract : The present paper focuses on thermal simulations and temperature measurements in a cutting tool during the machining process. The experimental studies deal with turning an AISI 1045 steel with cemented carbide insert (WC-%6Co). During machining, transient temperatures are measured at two points in cutting tool using the embedded thermocouple method. Three cutting force components are simultaneously recorded. The thermal simulations are based on the calculation of the heat flux from cutting forces and heat partition coefficient. Results obtained by thermal simulations are in good agreement with experimental ones.
Type de document :
Article dans une revue
WSEAS Transactions on Heat and Mass Transfer, World Scientific and Engineering Academy and Society (WSEAS), 2011, 6 (3), pp.71-80. 〈http://www.worldses.org/journals/hmt/heat-2011.htm〉
Liste complète des métadonnées

Littérature citée [28 références]  Voir  Masquer  Télécharger

https://hal.archives-ouvertes.fr/hal-01847794
Contributeur : Mines Albi Ecole Nationale Supérieure Des Mines d'Albi-Carmaux <>
Soumis le : mardi 25 septembre 2018 - 12:22:54
Dernière modification le : samedi 27 octobre 2018 - 01:19:31

Fichier

temperature-evolution.pdf
Fichiers produits par l'(les) auteur(s)

Identifiants

  • HAL Id : hal-01847794, version 1

Citation

Tchadja Kagnaya, Myriam Lazard, Laurence Lambert, Christine Boher, Thierry Cutard. Temperature evolution in a WC-6% Co cutting tool during turning machining : experiment and finite element simulations. WSEAS Transactions on Heat and Mass Transfer, World Scientific and Engineering Academy and Society (WSEAS), 2011, 6 (3), pp.71-80. 〈http://www.worldses.org/journals/hmt/heat-2011.htm〉. 〈hal-01847794〉

Partager

Métriques

Consultations de la notice

26

Téléchargements de fichiers

9