On the use of reduced bases in optimization of injection molding

Abstract : About 30% of the annual polymer production is transformed by injection molding. It is a cyclic process of forming a plastic into a desired shape by forcing the molten polymer under pressure into a hollow cavity (Agassant et al, 1991; Osswald, 1998). For thermoplastics polymers, the solidification is achieved by cooling. Typical cycle times range from 1 to 100 seconds and depend mainly on the cooling time. The complexity of molded parts is virtually unlimited, sizes may range from very small (<1mm) to very large (>1m), with an excellent control of tolerances.
Type de document :
Chapitre d'ouvrage
José Antonio Covas; Antonio Gaspar-Cunha. Optimization in polymer processing, Nova Science Publishers, pp.169-194, 2011, 9781611228182
Liste complète des métadonnées

Littérature citée [39 références]  Voir  Masquer  Télécharger

https://hal.archives-ouvertes.fr/hal-01007527
Contributeur : Gilles Marckmann <>
Soumis le : jeudi 11 mai 2017 - 14:28:47
Dernière modification le : mercredi 23 mai 2018 - 10:36:02
Document(s) archivé(s) le : samedi 12 août 2017 - 13:20:17

Fichier

CSC.pdf
Fichiers produits par l'(les) auteur(s)

Licence


Distributed under a Creative Commons Paternité 4.0 International License

Identifiants

  • HAL Id : hal-01007527, version 1

Citation

Francisco Chinesta, Fabrice Schmidt. On the use of reduced bases in optimization of injection molding. José Antonio Covas; Antonio Gaspar-Cunha. Optimization in polymer processing, Nova Science Publishers, pp.169-194, 2011, 9781611228182. 〈hal-01007527〉

Partager

Métriques

Consultations de la notice

305

Téléchargements de fichiers

27