Amphiphilic Polysaccharides : Useful Tools for the Preparation of Nanparticles with Controlled Surface Characteristics
Résumé
Polymeric surfactants obtained by hydrophobic modification of dextran are used as stabilizers for oil-in-water emulsions. The kinetics of interfacial tension decrease is studied as a function of polymer structural characteristics (degree of hydrophobic substitution) and at various polymer concentrations. Several hydrocarbon oils, either aliphatic (octane, decane, dodecane, and hexadecane) or aromatic (styrene), are tested. Kinetics exhibits the same general trends no matter which oil or polymer is considered. The emulsifying properties of the polymeric surfactants are illustrated by the preparation of oil-in-water emulsions. The droplet size at the preparation is correlated to the amount of oil and to the polymer concentration in the aqueous phase. For low polymer/oil ratios, it is shown that the droplet size is limited by the initial amount of polymer. On the contrary, for high polymer/oil ratios, the droplet size seems to level down, indicating that other parameters become predominant. Emulsion aging occurs by Ostwald ripening, and it is demonstrated that the theoretical equation of Lifshitz, Slyozov, and Wagner (LSW) correctly describes the experimental results. The nature of the oil has important effects on emulsion aging, as described by the LSW equation. The aging of emulsions containing oil mixtures is quantitatively described on the basis of the results with pure oils. The influence of polymer chemical structure can be conveniently correlated to interfacial tension results through the LSW equation. On the contrary, the influence of oil volume fraction seems to be overestimated by the usual correction factor, k(φ). The effect of temperature on emulsion aging is finally examined. Miniemulsions stabilized with dextran derivatives are used for the radical polymerization of styrene. Following this procedure, polysaccharide-covered polystyrene nanoparticles are prepared and characterized (size and surface coverage). The size of the particles is directly correlated to that of the initial droplets for styrene volume fractions around 10%. On the contrary, for initial styrene volume fractions around 20%, particles exhibit a larger size than the initial droplets, indicating that coalescence processes take place during polymerization. The amount of dextran at the surface of the particles is determined and compared to the adsorbed amounts resulting from emulsion preparation