Low friction MoS2TiW Coatings Manufactured on X38CrMoV5-1 Steel Using PVD Method

Marcin Golabczak , Philippe Jacquet (1) , Corinne Nouveau (2) , Romain Fliti (2)

1 ECAM Lyon - ECAM Lyon
2 LABOMAP - Laboratoire Bourguignon des Matériaux et Procédés

In this article the friction coefficients and the wear resistances of MoS2TiW protective coatings manufactured on X38CrMoV5-1 steel samples by using PVD technology are studied. The investi- gations based on tribometer tests which were carried out in different temperature conditions. The process of deposition of PVD coatings was realized by using multisource, hybrid factory- scale equipment of type URM 079. This equipment allows for deposition of coatings by the phys- ical method. The tribological tests were performed using a precision high temperature tribome- ter under ambient and high temperature conditions with a steel and corundum balls as coun- ter-samples. In this paper the results of these tribological tests are presented. It is shown that the measured friction coefficient of steel samples with PVD coatings is significantly lower than the friction coefficient of uncoated steel. It is also shown that X38CrMoV5-1 steel samples with manufactured MoS2TiW coatings are characterized by very low friction coefficient and high wear resistance.

Mots clés: PVD method; Cathodic Arc Evaporation; MoS2TiW coatings; Tribological investigations; Pin- on-disc test; Wear resistance

Domaines: Matériaux; Science des matériaux [cond-mat.mtrl-sci]; Matériaux; Mécanique des matériaux [physics.class-ph]

Marcin Golabczak, Philippe Jacquet, Corinne Nouveau, Romain Fliti. Low friction MoS2TiW Coatings Manufactured on X38CrMoV5-1 Steel Using PVD Method. Materials Science and Engineering Technology / Materialwissenschaft und Werkstofftechnik, 2013, 44 (5), pp.395-402. ⟨10.1002/mawe.201300142⟩. ⟨hal-02544639⟩