Wear behaviour on the radius portion of a die in deep-drawing: Identification, localisation and evolution of the surface damage

Abstract : The tribology behaviour of the die radius, in the deep-drawing process, results from surface interactions between the metal sheet and the tool under contact pressure. Friction, degradation of the sheet, surface quality and tool wear are a result of this interaction. This article aims to study degradations of the radius portion of a die in the deep-drawing process. The study on an industrial press is complex, so we developed our own test facility, an experimental device, which represents a deep-drawing process-simulator. It allows friction between the metal sheet and a die radius. It can dissociate the diverse mechanical effects exerted on the die radius by enabling a study of the component conditions found in deep-drawing (effect of the blankholder, of the pulling forces, the sliding rate, etc.). An experimental study was conducted on a low-carbon steel sheet and a X160CrMoV12 steel die radius. It revealed that the die radius surface was degraded by ploughing and transfer mechanisms. The distribution of these degradations on the die radius was localised in two areas but varied in intensity depending on the exit angle between the sheet and the die radius. The die radius friction coefficient has been modelled with respect to the mechanical characteristics of the deep-drawing process-simulator. This model leads to a correlation between the friction coefficient and the degradation evolutions on the die radius.
Type de document :
Article dans une revue
Wear, Elsevier, 2005, 259 (2, SI), pp.1097-1108. 〈10.1016/j.wear.2005.02.101〉
Liste complète des métadonnées

https://hal.archives-ouvertes.fr/hal-01717276
Contributeur : Mines Albi Ecole Nationale Supérieure Des Mines d'Albi-Carmaux <>
Soumis le : mercredi 7 novembre 2018 - 09:41:42
Dernière modification le : mardi 13 novembre 2018 - 09:19:16

Fichier

wear-behaviour.pdf
Fichiers produits par l'(les) auteur(s)

Identifiants

Collections

Citation

Christine Boher, D Attaf, Luc Penazzi, Christophe Levaillant. Wear behaviour on the radius portion of a die in deep-drawing: Identification, localisation and evolution of the surface damage. Wear, Elsevier, 2005, 259 (2, SI), pp.1097-1108. 〈10.1016/j.wear.2005.02.101〉. 〈hal-01717276〉

Partager

Métriques

Consultations de la notice

32