Low-Voltage Ride-Through Techniques for DFIG-Based Wind Turbines: State-of-the-Art Review and Future Trends

Marwa Ezzat (1) , Mohamed Benbouzid (1) , Sm Muyeen (2) , Lennart Harnefors (3)

1 LBMS - Laboratoire brestois de mécanique et des systèmes
2 PI - Electrical Engineering Department
3 ABB Corporate Research [Västerås]

This paper deals with low-voltage ride-through (LVRT) capability of wind turbines (WTs) and in particular those driven by a doubly-fed induction generator (DFIG). This is one of the biggest challenges facing massive deployment of wind farms. With increasing penetration of WTs in the grid, grid connection codes in most countries require that WTs should remain connected to the grid to maintain the reliability during and after a short-term fault. This results in LVRT with only 15% remaining voltage at the point of common coupling (PCC), possibly even less. In addition, it is required for WTs to contribute to system stability during and after fault clearance. To fulfill the LVRT requirement for DFIG-based WTs, there are two problems to be addressed, namely, rotor inrush current that may exceed the converter limit and the dc-link overvoltage. Further, it is required to limit the DFIG transient response oscillations during the voltage sag to increase the gear lifetime and generator reliability. There is a rich literature addressing countermeasures for LVRT capability enhancement in DFIGs; this paper is therefore intended as a comprehensive state-of-the-art review of solutions to the LVRT issue. Moreover, attempts are made to highlight future issues so as to index some emerging solutions.

Mots clés: Wind turbine; doubly-fed induction generator; low voltage ride-through; grid requirements

Domaines: Energie électrique

Marwa Ezzat, Mohamed Benbouzid, Sm Muyeen, Lennart Harnefors. Low-Voltage Ride-Through Techniques for DFIG-Based Wind Turbines: State-of-the-Art Review and Future Trends. IEEE IECON 2013, Nov 2013, Vienne, Austria. pp.7681-7686. ⟨hal-00926249⟩