A. Millecamps, J. F. Brunel, P. Dufrénoy, F. Garcin, and M. Nucci, Influence of Thermal Effects During Blade-Casing Contact Experiments, Volume 1: 22nd Biennial Conference on Mechanical Vibration and Noise, Parts A and B, 2009.
DOI : 10.1115/DETC2009-86842
URL : https://hal.archives-ouvertes.fr/hal-01223060

A. Batailly, M. Legrand, A. Millecamps, and F. Garcin, Numerical-Experimental Comparison in the Simulation of Rotor/Stator Interaction Through Blade-Tip/Abradable Coating Contact, Journal of Engineering for Gas Turbines and Power, p.134, 2012.
DOI : 10.1115/1.4006446
URL : https://hal.archives-ouvertes.fr/hal-00746632

M. Legrand, A. Batailly, P. , and C. , Numerical Investigation of Abradable Coating Removal in Aircraft Engines Through Plastic Constitutive Law, Journal of Computational and Nonlinear Dynamics, vol.7, issue.1, 2011.
DOI : 10.1115/1.4004951
URL : https://hal.archives-ouvertes.fr/hal-00627526

R. J. Williams, Simulation of Blade Casing Interaction Phenomena in Gas Turbines Resulting From Heavy Tip Rubs Using an Implicit Time Marching Method, Volume 6: Structures and Dynamics, Parts A and B, pp.2011-2011, 2011.
DOI : 10.1115/GT2011-45495

C. Padova, J. Barton, M. Dunn, and S. Manwaring, Experimental Results From Controlled Blade Tip/Shroud Rubs at Engine Speed, Journal of Turbomachinery, vol.129, issue.4, pp.713-723, 2007.
DOI : 10.1115/1.2720869
URL : https://hal.archives-ouvertes.fr/hal-01333702

A. Dadouche, M. J. Conlon, W. Dmochowski, B. Liko, and J. Bedard, Experimental Evaluation of Abradable Seal Performance at High Temperature, Volume 5: Structures and Dynamics, Parts A and B, 2008.
DOI : 10.1115/GT2008-51228
URL : https://hal.archives-ouvertes.fr/hal-01430519

C. Padova, M. Dunn, J. Barton, K. Turner, A. Turner et al., Casing Treatment and Blade-Tip Configuration Effects on Controlled Gas Turbine Blade Tip/Shroud Rubs at Engine Conditions, Journal of Turbomachinery, vol.133, issue.1, pp.11016-11017, 2012.
DOI : 10.1115/1.4000539

S. Michimura, A. Nagamatsu, and K. Asazuma, Vibration of impellers. III-an analysis of coupled vibrations between disk and blades using a reduced impedance method, JSME, Bulletin, issue.12, pp.22-1293, 1979.

S. Michimura, A. Nagamatsu, H. , Y. Ishikawa, and T. , Vibration of Impellers : 5th report, Measurement of Resonant Vibratory Stresses of an Impeller and Pressure Distribution Due to Aerodynamic Excitation, Bulletin of JSME, vol.27, issue.225, pp.534-539, 1984.
DOI : 10.1299/jsme1958.27.534

P. Almeida, C. Gibert, X. Leblanc, J. Ousty, and F. Thouverez, Experimental and Numerical Investigations on a Rotating Centrifugal Compressor, Volume 7: Structures and Dynamics, Parts A and B, pp.2012-2012, 2012.
DOI : 10.1115/GT2012-69760

N. Carpenter, R. Taylor, and M. Katona, Lagrange constraints for transient finite element surface contact, International Journal for Numerical Methods in Engineering, vol.1, issue.1, pp.103-128, 1991.
DOI : 10.1002/nme.1620320107
URL : https://hal.archives-ouvertes.fr/hal-01389918

M. Legrand, A. Batailly, B. Magnain, P. Cartraud, P. et al., Full threedimensional investigation of structural contact interactions in turbomachines, Journal of Sound and Vibration, issue.11, pp.331-2578, 2012.
URL : https://hal.archives-ouvertes.fr/hal-00660863

J. R. Bladh, Efficient predictions of the vibratory response of mistuned bladed disks by reduced order modeling, 2001.
URL : https://hal.archives-ouvertes.fr/tel-00358168

C. Jr, R. Bampton, and M. , Coupling of substructures for dynamic analysis, AIAA journal, vol.6, issue.7, pp.1313-1319, 1968.

A. Sternchüss and E. Balmès, On the reduction of quasi-cyclic disks with variable rotation speeds, Proceedings of the International Conference on Advanced Acoustics and Vibration Engineering (ISMA), pp.3925-3939, 2006.