The use of hat-shaped specimens to study the high strain rate shear behaviour of Ti-6Al-4V

J. Peirs , U.P. Verleysen , J. Degrieck , F. Coghe

To study the high strain rate shear behaviour of Ti-6Al-4V, hat-shaped specimens have been used in a compression split Hopkinson bar setup. With this technique, highly concentrated shear strains are obtained which eventually cause strain localization and adiabatic shear bands (ASB). Because of the complex stress distribution in the specimen, interpretation of the experimental results is not straightforward. In this paper, results of a comprehensive experimental and numerical study are presented, aiming at a more judicious use of hat-shaped specimens and a fundamental understanding of the obtained results. Specimens with different dimensions are considered. It is found that the width of the shear region and the radius of the corners are the most important parameters. The first mainly affects the homogeneity of stresses and deformations in the shear zone and the presence of a hydrostatic stress next to the shear stress, while the latter primarily governs the initiation of the ASB. The relation between the global measured response and the local material behaviour is studied. It is shown that, within certain limits, the shear stress in the shear region can be extracted from the measured force. Several experiments which have been interrupted at a certain level of deformation have been carried out. The microstructure could thus be observed at different stages: onset of strain localization, formation of ASBs, initiation and propagation of microcracks.

Mots clés: adiabatic shear band; titanium alloy; Ti-6Al-4V; Hopkinson; high strain rate; hat-shaped specimen; finite elements; fracture

Domaines: Physique [physics]

J. Peirs, U.P. Verleysen, J. Degrieck, F. Coghe. The use of hat-shaped specimens to study the high strain rate shear behaviour of Ti-6Al-4V. International Journal of Impact Engineering, 2010, 37 (6), pp.703. ⟨10.1016/j.ijimpeng.2009.08.002⟩. ⟨hal-00674106⟩