Infrared heating modeling of recycled PET preforms in injection stretch blow molding process

Anh-Duc Le (1) , Rémi Gilblas (1) , Vincent Lucin (1) , Yannick Le Maoult (1) , Fabrice Schmidt (1)

1 ICA - Institut Clément Ader

Relatively recent citizen’s consciousness about plastic pollution forces industrial actors of packaging to re-invent their shaping processes and materials. Specifically, for plastic bottle industry shaping, classical Polyethylene Terephthalate (PET) material is little by little replaced by recycled PET (rPET). The change in material composition due to recycling loops leads to an inevitable adaptation of the Injection Stretch Blow Molding (ISBM) process used to shape bottles at a satisfactory production rate. Indeed, rPET contains contaminants which modify its optical properties, so the heating stage becomes material-dependent and unstable regarding the polymer supplier. The approach adopted in this article is to build a numerical model able to simulate the infrared heating of rPET preforms, sensitive enough to predict changes in temperature due to the recycling rate. To do so, the optical properties of 50% and 100% rPET are measured by spectrometry and implemented in the simulation. Thermal radiative heat transfer between infrared lamps and rPET preforms is simulated by ray tracing method using an in-house software so-called RAYHEAT. Then, the result of the infrared ray tracing computation is used as the input heat source for thermal simulation by commercial software COMSOL Multiphysic® in order to simulate the temperature distribution of the preform. The numerical results are then confronted to experimental ones obtained on a research Stretch Blow Molding pilot, instrumented with thermography. The results show that the temperature obtained at the end of a classical heating cycle of the 100% recycled grade is 8 °C higher than the virgin one. Also, simulations confirm that this difference is attributed to changes in optical properties. Finally, heating 100% rPET at a sufficient forming temperature is about 8% less energy consuming than for virgin PET.

Mots clés: Recycled PET; Infrared heating; Halogen lamp; Modeling; Ray tracing method; IR thermography; Injection stretch blow molding

Domaines: Génie des procédés; Thermique [physics.class-ph]

Anh-Duc Le, Rémi Gilblas, Vincent Lucin, Yannick Le Maoult, Fabrice Schmidt. Infrared heating modeling of recycled PET preforms in injection stretch blow molding process. International Journal of Thermal Sciences, 2022, 181, pp.107762. ⟨10.1016/j.ijthermalsci.2022.107762⟩. ⟨hal-03712665⟩