V. Brizmer, Y. Kligerman, and I. Etsion, A laser surface textured parallel thrust bearing, Tribol Trans, vol.46, pp.397-403, 2003.

L. Mourier, D. Mazuyer, A. A. Lubrecht, and C. Donnet, Transient increase of film thickness in micro-textured EHL contacts, Tribol Int, vol.39, pp.1745-56, 2006.
URL : https://hal.archives-ouvertes.fr/ujm-00106745

L. Mourier, D. Mazuyer, F. P. Ninove, and A. A. Lubrecht, Lubrication mechanisms with laser-surface-textured surfaces in elastohydrodynamic regime, Proc Inst Mech Eng J, vol.224, pp.697-711, 2010.
URL : https://hal.archives-ouvertes.fr/hal-00663272

D. Mazuyer, E. Varenne, A. A. Lubrecht, J. Georges, and B. Constans, Shearing of adsorbed polymer layers in an elastohydrodynamic contact in pure sliding, pp.493-504, 1999.
URL : https://hal.archives-ouvertes.fr/hal-00663294

C. Meunier, Vieillissement des lubrifiants et compréhension des mécanismes de dégradation: Application à la zone segment-piston-chemise, pp.2008-2037, 2008.

A. Ernesto, D. Mazuyer, and J. Cayer-barrioz, The combined role of soot aggregation and surface effect on the friction of a lubricated contact, Tribol Lett, vol.55, pp.329-370, 2014.

A. Ernesto, D. Mazuyer, and J. Cayer-barrioz, From full-film lubrication to boundary regime in transient kinematics, Tribol Lett, vol.59, issue.1, pp.1-10, 2015.

C. J. Hooke, The minimum film thickness in lubricated line contacts during a reversal of entrainment -General solution and development of a design chart, Proc Inst Mech Eng, vol.208, pp.53-64, 1994.

J. Sugimura and H. A. Spikes, Technique for measuring EHD film thickness in non steady-state contact conditions, pp.91-100, 1996.

J. Sugimura, J. Jr, W. R. Spikes, and H. A. , EHD film thickness in non-steady state contacts, Trans ASME, vol.120, pp.442-52, 1998.

J. Sugimura, T. Okumura, Y. Yamamoto, and H. A. Spikes, Simple equation for EHL film thickness under acceleration, Tribol Int, vol.32, pp.117-140, 1999.

R. Glovnea and H. A. Spikes, Behavior of EHD films during reversal of entrainment in cyclically accelerated/decelerated motion, Tribol Trans, vol.45, pp.177-84, 2002.

J. Wang, T. Hashimoto, H. Nishikawa, and M. Kaneta, Pure rolling elastohyddrodynamic lubrication of short stroke reciprocating motion, Tribol Int, vol.38, pp.1013-1034, 2005.

R. Bassani, E. Ciulli, M. Carli, and K. Stadler, Experimental investigation of transient and thermal effects on lubricated non-conformal contacts, Tribotest, vol.13, pp.183-94, 2007.

E. Ciulli, Non-steady state non-conformal contacts: friction and film thickness studies, Meccanica, vol.44, pp.409-434, 2009.

B. J. Hamrock and D. Dowson, Isothermal elastohydrodynamic lubrication of point contacts: Part III -fully flooded results, J Lubr Technol, 1977.

G. Nijenbanning, C. H. Venner, and H. Moes, Film thickness in elastohydrodynamically lubricated elliptic contacts, Wear, vol.176, pp.217-246, 1994.

N. Ohno and S. Yamada, Effect of high-pressure rheology of lubricants upon entrapped oil film behaviour at halting elasto-hydrodynamic lubrication, Proc Inst Mech Eng J, vol.221, pp.279-85, 2007.

D. Mazuyer, A. Ernesto, and J. Cayer-barrioz, Theoretical modeling of filmforming mechanisms under transient conditions: Application to deceleration and experimental validation, Tribol Lett, vol.65, pp.22-36, 2017.

A. I. Petrousevitch, D. S. Kodnir, R. G. Salukvadze, D. L. Bakashvili, and V. Schwarzman, The investigation of oil film thickness in lubricated ball-race rolling contact, Wear, vol.19, pp.369-89, 1972.

M. Yahiaoui, E. Rigaud, D. Mazuyer, and J. Cayer-barrioz, Forced oscillations dynamic tribometer with real-time insights of lubricated interfaces, Rev Sci Instrum, vol.88, p.35101, 2017.
URL : https://hal.archives-ouvertes.fr/hal-02068274

L. D. Wedeven, D. Evans, and A. Cameron, Optical analysis of ball bearing starvation, ASME conference, 1970.

Y. P. Chiu, An analysis and prediction of lubricant film starvation in rolling contact systems, ASLE Trans, vol.17, pp.22-35, 1974.

J. Pemberton and A. Cameron, A mechanism of fluid replenishment in elastohydrodynamic contacts, Wear, vol.37, pp.185-90, 1976.

E. Kingsbury, Parched elastohydrodynamic lubrication, J Tribol, vol.107, pp.229-261, 1985.

F. Chevalier, INSA Lyon, Modélisation des conditions d'alimentation dans les contacts elastohydrodynamiques ponctuels, 1996.
URL : https://hal.archives-ouvertes.fr/hal-01670846

F. Chevalier, A. A. Lubrecht, P. Cann, and G. Dalmaz, The evolution of lubricant film defects in the starved regime, Tribology for energy conservation, Proceedings of the 24th Leeds-Lyon symposium in tribology, vol.34, pp.233-275, 1998.

B. Damiens, Modélisation de la lubrification sous-alimentée dans les contacts elastohydrodynamiques elliptiques, 2003.

T. Touche, T. Woloszynski, P. Podsiadlo, G. W. Stachowiak, J. Cayer-barrioz et al., Numerical simulations of groove topography effects on film thickness and friction in EHL regime, Tribol Lett, vol.65, p.113, 2017.

F. Chevalier, A. A. Lubrecht, P. Cann, and G. Dalmaz, Film thickness in starved EHL point contacts, J Tribol, vol.120, pp.126-159, 1998.

B. Damiens, C. H. Venner, P. Cann, and A. A. Lubrecht, Starved lubrication of elliptical EHD contacts, J Tribol, vol.120, pp.126-159, 1998.
URL : https://hal.archives-ouvertes.fr/hal-00450601