Aerosol-Cloud Closure Study on Cloud Optical Properties using Remotely Piloted Aircraft Measurements during a BACCHUS Field Campaign in Cyprus

Radiance Calmer (1) , Gregory Roberts (1, 2) , Kévin Sanchez (1, 2) , Jean Sciare (3) , Karine Sellegri (4) , David Picard (4) , Mihalis Vrekoussis (5) , Michael Pikridas (6)

1 CNRM - Centre national de recherches météorologiques
2 SIO - UC San Diego - Scripps Institution of Oceanography
3 LSCE - Laboratoire des Sciences du Climat et de l'Environnement [Gif-sur-Yvette]
4 LaMP - Laboratoire de Météorologie Physique
5 IUP - Institute of Environmental Physics [Bremen]
6 EEWRC - Energy, Environment and Water Research Center

In the framework of the EU-FP7 BACCHUS project, an intensive field campaign was performed in Cyprus (2015/03). Remotely Piloted Aircraft System (RPAS), ground-based instruments, and remote-sensing observations were operating in parallel to provide an integrated characterization of aerosol-cloud interactions. Remotely Piloted Aircraft (RPA) were equipped with a 5-hole probe, pyranometers, pressure, temperature and humidity sensors, and measured updraft velocity at cloud base and cloud optical properties of a stratocumulus layer. Ground-based measurements of dry aerosol size distributions and cloud condensation nuclei spectra, and RPA observations of vertical wind velocity and meteorological state parameters are used here to initialize an Aerosol–Cloud Parcel Model (ACPM) and compare the in situ observations of cloud optical properties measured by the RPA to those simulated in the ACPM. Two different cases are studied with the ACPM, including an adiabatic case and an entrainment case, in which the in-cloud temperature profile from RPA is taken into account. Adiabatic ACPM simulation yields cloud droplet number concentrations at cloud base (ca. 400 cm−3) that are similar to those derived from a Hoppel minimum analysis. Cloud optical properties have been inferred using the transmitted fraction of shortwave radiation profile measured by downwelling and upwelling pyranometers mounted on a RPA, and the observed transmitted fraction of solar radiation is then compared to simulations from the ACPM. ACPM simulations and RPA observations show better agreement when associated with entrainment compared to that of an adiabatic case. The mean difference between observed and adiabatic profiles of transmitted fraction of solar radiation is 0.12, while this difference is only 0.03 between observed and entrainment profiles. A sensitivity calculation is then conducted to quantify the relative impacts of two-fold changes in aerosol concentration, and updraft velocity to highlight the importance of accounting for the impact of entrainment in deriving cloud optical properties, as well as the ability of RPAs to leverage ground-based observations for studying aerosol–cloud interactions.

Mots clés: optical properties; aerosol; cloud; UAV; drone; ChArMEx

Domaines: Océan, Atmosphère; Physique Atmosphérique et Océanique [physics.ao-ph]; Ingénierie de l'environnement

Radiance Calmer, Gregory Roberts, Kévin Sanchez, Jean Sciare, Karine Sellegri, et al.. Aerosol-Cloud Closure Study on Cloud Optical Properties using Remotely Piloted Aircraft Measurements during a BACCHUS Field Campaign in Cyprus. Atmospheric Chemistry and Physics, 2019, ⟨10.5194/acp-19-13989-2019⟩. ⟨hal-02332534⟩