Panel of resonators with variable resonance frequency for noise control
Résumé
The article focuses on acoustic resonators made of perforated sheets bonded onto honeycomb cavities. This kind of resonators can be used in adverse conditions such as high temperature, dirt and mechanical constraints. For all these reasons, they are, for example, widely used in aeronautic applications. The acoustic properties are directly linked to the size, shape and porosity of holes and to the thickness of air gaps. Unfortunately, the acoustic absorption of these resonators is selective in frequency and conventional acoustic resonators are only well adapted to tonal noises. In case of variable tonal noise, the efficiency is limited if the resonators are not tunable. One common solution is to control the depth of cavities based on the noise to be attenuated. This article proposes another technology of tunable resonators with only a very small mass and size increase. It consists of two superposed and identically perforated plates associated with cavities. One plate is fixed and bonded to the cavities and the other plate is mobile. The present concept enables to change the internal shapes of the holes of the perforated layers. The article describes this system and gives a theoretical model of the normal incidence acoustic impedance that allows to predict the acoustic behavior, in particular the resonance frequency. The model shows that the resonance frequency varies with hole profiles and that the absorption peak moves towards the lower frequencies. The proposed model is validated by measurements on various configurations of resonators tested in an impedance tube. The perspectives of this work are to adapt the hole profiles using an actuator in order to perform active control of impedance.