Machinability and surface quality during high speed trimming of multi directional CFRP - Archive ouverte HAL Accéder directement au contenu
Article Dans Une Revue International Journal of Machining and Machinability of Materials Année : 2013

Machinability and surface quality during high speed trimming of multi directional CFRP

Madjid Haddad
Redouane Zitoune
Florent Eyma
Bruno Castanié

Résumé

In this paper, high speed trimming of a multidirectional CFRP using unused and used burr tools is considered in order to investigate the influence of the machining parameters (e.g., feed speed, cutting speed and cutting distance) on the cutting forces, machining temperature, and the machined surface quality. To estimate the effect of the tools’ wear and cutting parameters on the cutting forces and surface roughness, a statistical method (ANOVA) has been used. When considering an unused tool, the recorded temperatures were below the glass transition temperature of the composite material (Tg). In the case of used tools, these temperatures were mostly higher than the Tg. Furthermore, SEM observations of the machined surface showed damaged areas. These areas were wider when the cutting distance increased. Statistical analyses have shown that the machining parameters have a significant influence on the variation of the machined surface quality and the cutting forces.
Fichier non déposé

Dates et versions

hal-02078611 , version 1 (25-03-2019)

Identifiants

Citer

Madjid Haddad, Redouane Zitoune, Florent Eyma, Bruno Castanié. Machinability and surface quality during high speed trimming of multi directional CFRP. International Journal of Machining and Machinability of Materials, 2013, 13 (2/3), pp.289. ⟨10.1504/IJMMM.2013.053229⟩. ⟨hal-02078611⟩
113 Consultations
0 Téléchargements

Altmetric

Partager

Gmail Facebook X LinkedIn More