A. Tropis, M. Thomas, J. L. Bounie, and P. Lafon, Certification of the composite outer wing of the ATR72, J Aerosp Eng, vol.209, pp.327-366, 1994.

K. Y. Huang, D. Boer, A. Akkerman, and R. , Analytical modeling of impact resistance and damage tolerance of laminated composite plates, AIAA J, vol.46, issue.11, pp.2760-72, 2008.

R. C. Combes, Design for damage tolerance, J Aircraft, vol.7, issue.1, pp.18-20, 1970.

S. Abrate, Impact on Composites Structures, 1998.

O. Eve, Etude du comportement des structures composites endommagées par impact basse vitesse PhD Thesis France: University of Metz, 1999.

M. Richardson and M. J. Wisheart, Review of low-velocity impact properties of composite materials, Compos A, vol.27, issue.12, pp.1123-1154, 1996.

W. J. Cantwell and J. Morton, The impact resistance of composite materials-a review, Composites, vol.22, issue.5, pp.347-62, 1991.

P. Feraboli and K. T. Kedward, Enhanced evaluation of the low-velocity impact response of composite plates, AIAA J, vol.42, issue.10, pp.2143-52, 2004.

A. L. Pilchak, T. Uchiyama, and D. Liu, Low velocity impact response of small-angle laminated composites, AIAA J, vol.44, issue.12, pp.3080-3087, 2006.

R. Olsson, Analytical prediction of large mass impact damage in composite laminates, Compos A, vol.32, pp.1207-1222, 2001.

G. Zhou, The use of experimentally-determined impact force as damage measure in impact damage resistance and tolerance of composite structures, Compos Struct, vol.42, pp.375-82, 1998.

H. Suemasu, T. Kumagai, and K. Gozu, Compressive behavior of multiply delaminated composite laminates part 1: experiment and analytical development, AIAA J, vol.36, issue.7, pp.1279-85, 1998.

H. Suemasu and T. Kumagai, Compressive behavior of multiply delaminated composite laminates part 2: finite element analysis, AIAA J, vol.36, issue.7, pp.1286-90, 1998.

J. Rouchon, Certification of Large Aircraft Composite Structures, Recent Progress and New Trends in Compliance Philosophy, 17th ICAS, 1990.

E. Acar, R. T. Haftka, and N. H. Kim, Effects of structural tests on aircraft safety, AIAA J, vol.48, issue.10, pp.2235-2283, 2010.

C. S. Lopes, P. P. Camanho, Z. Gurdal, P. Maimi, and E. V. Gonzalez, Low-Velocity impact damage on dispersed stacking sequence laminates. Part II: numerical simulations, Compos Sci Technol, vol.69, issue.7-8, pp.937-984, 2009.

C. Menna, D. Asprone, G. Caprino, V. Lopresto, and A. Prota, Numerical simulation of impact tests on GFRP composite laminates, Int J Impact Eng, vol.38, pp.677-85, 2011.
URL : https://hal.archives-ouvertes.fr/hal-00829115

C. S. Lopes, S. Sadaba, C. Gonzalez, J. L. Lorca, and P. P. Camanho, Physically-sound simulation of low-velocity impact on fiber reinforced laminates, Int J Impact Eng, vol.92, pp.3-17, 2015.

G. A. Schoeppner and S. Abrate, Delamination threshold loads for low velocity impact on composite laminate, Compos A, vol.31, pp.903-918, 2000.

Y. Shi, T. Swait, and C. Soutis, Modelling damage evolution in composite laminate subjected to low velocity impact, Compos Struct, vol.94, issue.9, pp.2902-2915, 2012.

D. J. Elder, R. S. Thomson, M. Q. Nguyen, and M. L. Scott, Review of delamination predictive methods for low speed impact of composite laminates, Compos Struct, vol.66, issue.1-4, pp.677-83, 2004.

L. Lammerant and I. Verpoest, Modelling of the interaction between matrix cracks and delaminations during impact of composite plates, Compos Sci Technol, vol.56, issue.10, pp.1171-1179, 1996.

S. Li, S. R. Reid, and Z. Zou, Modelling damage of multiple delaminations and transverse matrix cracking in laminated composites due to low velocity lateral impact, Compos Sci Technol, vol.66, pp.827-863, 2006.

H. Razi and A. S. Kobayashi, Delamination in cross-ply laminated composite subjected to low-velocity impact, AIAA J, vol.31, issue.8, pp.1498-502, 1993.

M. De-moura and J. Gonçalves, Modelling the interaction between matrix cracking and delamination in carbon-epoxy laminates under low velocity impact, Compos Sci Technol, vol.64, pp.1021-1028, 2004.

W. E. Bachrach and R. S. Hansen, Mixed finite-element method for composite cylinder subjected to impact, AIAA J, vol.27, issue.5, pp.632-640, 1989.

S. R. Hallett, W. G. Jiang, B. Khan, and M. R. Wisnom, Modelling the interaction between matrix cracks and delamination damage in scaled quasi-isotropic specimens, Compos Sci Technol, vol.68, issue.1, pp.80-89, 2008.

Z. Aslan and M. Sahin, Buckling behaviour and compressive failure of composite laminates containing multiple large delaminations, Compos Struct, vol.89, pp.382-90, 2009.

T. D. Dang and S. R. Hallett, A numerical study on impact and compression after impact behavior of variable angle tow laminates, Compos Struct, vol.96, pp.194-206, 2013.

D. S. Dugdale, Yielding of steel sheets containing slits, J Mech Phys Solids, vol.8, pp.100-108, 1960.

D. P. Makhecha, R. K. Kapania, E. R. Johnson, and D. A. Dillard, Dynamic fracture analysis of adhesively bonded joints using explicit methods, AIAA J, vol.45, issue.11, pp.2778-84, 2007.

G. I. Barenblatt, The mathematical theory of equilibrium of cracks in brittle fracture, Adv Appl Mech, vol.7, pp.55-129, 1962.

A. Faggiani and B. G. Falzon, Predicting low-velocity impact damage on a stiffened composite panel, Compos A, vol.41, issue.6, pp.737-786, 2010.

E. V. Iarve, M. R. Gurvich, D. H. Mollenhauer, C. A. Rose, and C. G. Davila, Mesh-independent matrix cracking and delamination modeling in laminated composites, Int J Numer Methods Eng, vol.88, pp.749-73, 2011.

A. Turon, P. P. Camanho, J. Costa, and J. Renart, Accurate simulation of delamination growth under mixed-mode loading using cohesive elements: Definition of interlaminar strengths and elastic stiffness, Compos Struct, vol.92, pp.1857-64, 2010.

P. W. Harper, L. Sun, and S. R. Hallett, A study on the influence of cohesive zone interface element strength parameters on mixed mode behavior, Compos A, vol.43, pp.722-756, 2012.

M. V. Donadon, L. Iannucci, B. G. Falzon, J. M. Hodgkinson, and S. De-almeida, A progressive failure Model for composite laminates subjected to low velocity impact damage, Comput Struct, vol.86, pp.1232-52, 2008.

C. Bouvet, B. Castanié, M. Bizeul, and J. J. Barrau, Low velocity impact modelling in laminate composite panels with discrete interface elements, Int J Solids Struct, vol.46, pp.2809-2830, 2009.
URL : https://hal.archives-ouvertes.fr/hal-01851855

E. V. Gonzalez, P. Maimi, P. P. Camanho, A. Turon, and J. A. Mayug, Simulation of dropweight impact and compression after impact tests on composite laminates, Compos Struct, vol.91, issue.11, pp.3364-78, 2012.

W. Tan, B. G. Falzon, L. Chiu, and M. Price, Predicting low velocity impact damage and Compression-After-Impact (CAI) behavior of composite laminates, Compos A, vol.71, pp.212-238, 2015.

E. Panettieri, D. Fanteria, and F. Danzi, Delamination growth in compression after impact test simulations: Influence of cohesive elements parameters on numerical results, Compos Struct, vol.137, pp.140-147, 2016.

B. L. Wardle and P. A. Lagace, On the use of dent depth as an impact damage metric for thin composite structures, J Reinf Plast Compos, vol.16, issue.12, pp.1093-110, 1997.

P. Chen, Z. Shen, and J. Xiong, Failure mechanisms of laminated composites subjected to static indentation, Compos Struct, vol.75, issue.1-4, pp.489-95, 2006.

C. Bouvet, S. Rivallant, and J. J. Barrau, Low velocity impact modeling in composite laminates capturing permanent indentation, Compos Sci Technol, vol.72, issue.16, pp.1977-88, 2012.
URL : https://hal.archives-ouvertes.fr/hal-01853076

W. He, Z. Guan, X. Li, and D. Liu, Prediction of permanent indentation due to impact on laminated composites based on an elasto-plastic model incorporating fiber failure, Compos Struct, vol.96, pp.232-274, 2013.

N. Hongkarnjanakul, C. Bouvet, and S. Rivallant, Validation of low velocity impact modeling on different stacking sequences of CFRP laminates and influence of fibre failure, Compos Struct, vol.106, pp.549-59, 2013.

S. Rivallant, C. Bouvet, and N. Hongkarnjanakul, Failure analysis of CFRP laminates subjected to Compression After Impact : FE simulation using discrete interface elements, Compos A, vol.55, pp.83-93, 2013.
URL : https://hal.archives-ouvertes.fr/hal-00869432

H. A. Israr, S. Rivallant, and J. J. Barrau, Experimental investigation on mean crushing stress characterization of carbon-epoxy plies under compressive crushing mode, Compos Struct, vol.96, pp.357-64, 2013.
URL : https://hal.archives-ouvertes.fr/hal-00784973

A. , Standard Test Method for Measuring the Damage Resistance of a fiber-reinforced polymer matrix composit to a drop-weight impact event, 2015.

A. D7137m, Standard Test Method for Compressive Residual Strength Properties of Damaged Polymer Matrix Composite Plates, ASTM editor, 2012.