M. N. Islam, A. Broswell, and . Pramanik, An Investigation of Dimensional Accuracy of Parts Produced by Three-Dimensional Printing, Proceedings of the World Congress on Engineering 2013 Vol I, WCE 2013, 2013.

P. Jacobs, Rapid prototyping and Manufacturing: Fundamentals of stereolithography, Society of Manufacturing Engineers, 1992.

S. Moylan, J. Slotwinski, A. Cooke, K. Jurrens, and M. A. Donmez, Proposal for a Standardized Test Artefact for Additive Manufacturing Machines and Processes Proceeding of the Solid Free Form Fabrication Symposium, 2012.

L. Yang, An investigation of standard test part design for additive manufacturing, Proceeding of the Solid Free Form Fabrication Symposium, 2014.

M. N. Islam and S. Sacks, An experimental investigation into the dimensional error of powder-binder three-dimensional printing, The International Journal of Advanced Manufacturing Technology, vol.102, issue.5, pp.1371-1380, 2016.
DOI : 10.1007/s00170-015-7482-7

M. B. Mccarthy, S. B. Brown, ;. Evenden, and A. D. Robinson, NPL freeform artefact for verification of non-contact measuring systems, Three-Dimensional Imaging, Interaction, and Measurement, pp.78640-78650, 1117.
DOI : 10.1117/12.876705

I. Gibson, D. Rosen, and B. Stucker, Additive manufacturing technologies, chapter 8 Binder jetting, 2015.

K. Michalakis, A. Stratos, H. Hirayama, A. Pissiotis, and F. Touloumi, Delayed setting and hygroscopic linear expansion of three gypsum products used for cast articulation, The Journal of Prosthetic Dentistry, vol.102, issue.5, pp.313-318, 2009.
DOI : 10.1016/S0022-3913(09)60181-5