Observability analysis of pmsm, Signals, Circuits and Systems (SCS), 2009 3rd International Conference on, pp.1-6, 2009. ,
Dsp-based extended kalman filter estimation of speed and rotor position of a pm synchronous motor, Industrial Electronics, Control and Instrumentation, vol.3, pp.2097-2102, 1994. ,
Application of sliding observer to sensorless permanent magnet synchronous motor drive system, Power Electronics Specialists Conference, PESC '94 Record., 25th Annual IEEE, vol.1, pp.532-536, 1994. ,
Sensorless sliding-mode mtpa control of an ipm synchronous motor drive using a sliding-mode observer and hf signal injection, Industrial Electronics, IEEE Transactions on, vol.57, issue.4, pp.1270-1278, 2010. ,
Sensorless position control for spmsm at zero speed and acceleration, Proceedings of the 2011-14th European Conference on, pp.1-9, 2011. ,
URL : https://hal.archives-ouvertes.fr/hal-00704657
Pressure observer-controller design for pneumatic cylinder actuators, Mechatronics, IEEE/ASME Transactions on, vol.7, issue.4, pp.490-499, 2002. ,
A globally stable, load-independent pressure observer for the servo control of pneumatic actuators, Mechatronics, IEEE/ASME Transactions on, vol.14, issue.3, pp.295-306, 2009. ,
Comparison of differentiation schemes for the velocity and acceleration estimations of a pneumatic system, 2014. ,
URL : https://hal.archives-ouvertes.fr/hal-00980870
Non-linear position control of a pneumatic actuator with closed-loop stiffness and damping tuning, in: Decision and Control, European Control Conference. ECC, pp.4385-4390, 2013. ,
Control of electrical Drives, 1990. ,
Design of pneumatic actuator systems, 1977. ,
Pneumatic drives, 2007. ,
Modelling a loaded two-way pneumatic actuator, Journal of Dynamic Systems Measurements and Control, vol.9, issue.1, pp.19-25, 1976. ,
The effect of backslash and speed-dependent friction on the stability of closed-cycle control systems, Journal of the institution of electrical engineers, vol.94, issue.2A, pp.143-151, 1947. ,
A survey of models, analysis tools and compensation methods for the control of machines with friction, Automatica, vol.30, issue.7, pp.1083-1138, 1994. ,
Study of" sticking and restarting phenomenon" in electropneumatic positioning systems, Journal of Dynamic Systems, Measurement, and Control, vol.127, issue.1, pp.173-184, 2005. ,
URL : https://hal.archives-ouvertes.fr/hal-00140643
Cascaded control concept of a robot with two degrees of freedom driven by four artificial pneumatic muscle actuators, in: American Control Conference, Proceedings of the 2005, vol.1, pp.680-685, 2005. ,
Discharge characteristics of servo valve orifices, Fluid Power International conference, pp.43-503, 1968. ,
Model-based pressure and torque control for innovative pneumatic soft-actuators, Conf. Proc., 7th International Conference on Fluid Power (7th IFK), pp.291-302, 2010. ,
Analytical model of the flow stage of a pneumatic servo-distributor for simulation and nonlinear control, The sixth Scandinavian international conference on fluid power, pp.847-860, 1999. ,
Robust exact differentiation via sliding mode technique, Automatica, vol.34, issue.3, pp.379-384, 1998. ,
DOI : 10.1016/s0005-1098(97)00209-4
An algebraic framework for linear identification, ESAIM: Control, Optimisation and Calculus of Variations, vol.9, pp.151-168, 2010. ,
, IEEE Transactions on, vol.22, issue.5, pp.728-740, 1977.
Stability theory by lyapunov's second method, The mathematical Society of, Japan, issue.9, p.223, 1966. ,
Nonlinear control systems, vol.2, 1989. ,
Adaptive higher order sliding modes for two-dimensional derivative estimation, Proceedings of the 18th IFAC World Congress, vol.18, pp.3063-3071, 2011. ,
URL : https://hal.archives-ouvertes.fr/hal-00747380