Wall shear rates and stagnation mass transfer on a plate in axisymmetric and cross impinging jets

Amina Meslem (1) , Magdalena Kristiawan (2) , Ilinca Nastase (3) , Vaclav Sobolik (1)

1 LaSIE - Laboratoire des Sciences de l'Ingénieur pour l'Environnement - UMR 7356
2 BIA - Unité de recherche sur les Biopolymères, Interactions Assemblages
3 Technical University of Civil Engineering

This article presents a study on the wall shear rate and mass transfer of impinging jets on a flat plate in the vicinity of stagnation point. The performance of a cross-shaped orifice nozzle was compared with a reference convergent circular nozzle having similar equivalent diameter. An array of electrodiffusion micro probes inserted into the plate was used for wall shear rates measurements. Mass transfer in the impinging region was calculated from the measured wall shear rates for a Reynolds number around 5500 and over a range of streamwise distances between the nozzle and the impinging plane within 1 to 5 nozzle equivalent diameters. The most important observation in the present investigation is that the wall shear rates and the mass transfer in the impingement region of the cross-shaped orifice nozzle are up to 175% and 40%, respectively, higher than that of the convergent nozzle. The performance of the cross-shaped orifice jet is probably related to its particular vortex dynamics characteristic of the near exit region. All the results confirm that the jet passive control enhance the mass transfer.

Mots clés: impinging jets; electrodiffusion micro probes; wall shear rate

Domaines: Mécanique des fluides [physics.class-ph]

Amina Meslem, Magdalena Kristiawan, Ilinca Nastase, Vaclav Sobolik. Wall shear rates and stagnation mass transfer on a plate in axisymmetric and cross impinging jets. Journal of Physics: Conference Series, 2012, 395 (012034), pp.1-8. ⟨10.1088/1742-6596/395/1/012034⟩. ⟨hal-01174306⟩