Calibration of the insert/tool holder thermal contact resistance in stationary 3D turning

Alexandre Mondelin (1) , Frédéric Valiorgue (1) , Eric Feulvarch (1) , Joël Rech (1) , Michel Coret (2)

1 LTDS - Laboratoire de Tribologie et Dynamique des Systèmes
2 LaMCoS - Laboratoire de Mécanique des Contacts et des Structures [Villeurbanne]

Modeling machining processes, especially turning, is the subject of a large number of studies today. The objective is to optimize cutting conditions and improve tool lifetime as well as the quality of the pieces produced. However studying various phenomena such as tool wear requires simulating very long machining times in order to reach the stabilized state, among other things. These stationary simulations require a very good calibration of the limit conditions representing the experimental reality. In particular, the thermal contact resistance of the insert/tool-holder body contact plays a very significant part in removing the heat generated. The aim of this article is to propose an experiment/simulation procedure to calibrate this resistance. Based on laser heating and temperature measurement, a numerical sensitivity study has made it possible to estimate the value of this resistance in the case of a non-coated insert and a carbide body.

► Estimation of the insert/shim/tool-holder thermal contact resistance (RTC).
► Calibration procedure of thermal contact resistance based on laser heating.
► 3D numerical model of turning device used for inverse method of RTC quantification.
► Sensitivity study of the RTC value impact on heat discharge during turning.

Mots clés: Turning; Thermal contact resistance; Laser heating; Heat flux identification

Domaines: Mécanique [physics.med-ph]; Matériaux

Alexandre Mondelin, Frédéric Valiorgue, Eric Feulvarch, Joël Rech, Michel Coret. Calibration of the insert/tool holder thermal contact resistance in stationary 3D turning. Applied Thermal Engineering, 2013, 55, pp.17-25. ⟨10.1016/j.applthermaleng.2013.02.012⟩. ⟨hal-01005922⟩