Propane dry reforming to synthesis gas over Ni-based catalysts: Influence of support and operating parameters on catalyst activity and stability

L. B. Råberg (1) , Jensen B Morten (1) , Unni Olsbye (1) , C. Daniel (2) , Stéphane Haag (2) , Claude Mirodatos (2) , Anja Olafsen Sjåstad (1)

1 UiO - University of Oslo
2 IRC - Institut de recherches sur la catalyse

A series of supported Ni catalysts (2 wt% Ni) were tested for the dry reforming of propane to synthesis gas reaction at 600 °C, C3H8:CO2:H2:N2 (%) = 10:30:10:50, 1 atm and GHSV = 13333 Nml/(h gcat). The support systems studied range from acidic (SiO2) to amphoteric [Al2O3, Mg(Al)O] to basic oxides [MgO, CaO], with BET areas of 100, 100 (131 and 173), 117, and 16 m2/g, respectively. Ni particle size and reduction state was investigated by magnetic measurements, performed before and during catalytic testing. Support basicity was measured by CO2 TPD. It was observed that the intrinsic activity of the catalysts (TOF) depends strongly on the Ni particle size (D) in the size range of 4.5–11 nm. As such, a TOF versus D plot showed an exponential inverse relationship, much more pronounced than previously reported for the methane dry reforming reaction. In turn, a volcano-type correlation was found between intrinsic catalyst activity and support basicity. As a result, the best catalytic performance, including a low selectivity to methane, was observed on the most dispersed Ni particles supported on Mg(Al)O. Key mechanistic features were derived from these observations.

Mots clés: Support basicity; Ni particle size; Ni catalysts; Synthesis gas; Methane dry reforming; Propane dry reforming

Domaines: Catalyse; Chimie organique

L. B. Råberg, Jensen B Morten, Unni Olsbye, C. Daniel, Stéphane Haag, et al.. Propane dry reforming to synthesis gas over Ni-based catalysts: Influence of support and operating parameters on catalyst activity and stability. Journal of Catalysis, 2007, 249 (2), pp.250-260. ⟨10.1016/j.jcat.2007.04.004⟩. ⟨hal-00180878⟩