Imaging gas and plasma interactions in the surface-chemical modification of polymers using micro-plasma jets

Jun-Seok Oh (1) , Olumuyiwa T Olabanji (1) , Craig Hale (2) , Raffaello Mariani (2) , Konstantinos Kontis (2) , James W Bradley (1)

1 Department of Electrical Engineering and Electronics
2 MACE - School of Mechanical Aerospace and Civil Engineering [Manchester]

This paper reports on the correlation between gas flow and plasma behaviour in the outflow of a micro-atmospheric pressure plasma jet (µ-APPJ: capillary 1mm and operating in helium) using both 2-D optical imaging and Schlieren photography. Schlieren photography shows that the helium outflow changes from laminar to turbulent conditions after distances between 20 and 50 mm from nozzle. Above a flow rate of 1.4 slm, the length of the laminar region decreases with increasing flow rate. However, by contrast the visible plasma plume increases in length with increasing flow rate until its extension just exceeds that of the laminar region. At this point the plasma becomes turbulent and its length decreases. Exposing polystyrene samples to the plasma jet significantly alters the water contact angle in a defined area, with the hydrophobic polystyrene surface becoming more hydrophilic. This modification occurs both with and without direct contact of the visible glow on the surface. The radius of the treated area is much larger than the width of the visible jet but much smaller than the area of the turbulence on the surface. The treated area reduces with increasing nozzle-substrate distance.

Mots clés: Physical Sciences

Jun-Seok Oh, Olumuyiwa T Olabanji, Craig Hale, Raffaello Mariani, Konstantinos Kontis, et al.. Imaging gas and plasma interactions in the surface-chemical modification of polymers using micro-plasma jets. Journal of Physics D: Applied Physics, 2011, 44 (15), pp.155206. ⟨10.1088/0022-3727/44/15/155206⟩. ⟨hal-00613264⟩