 |
|
|
|
| HAL : hal-00541133, version 1 |
| DOI : 10.1163/016942410X503320 |
| Fiche détaillée |  Récupérer au format |
|
|
| Journal of Adhesion Science and Technology 25, 1-3 (2011) 213-221 |
|
|
|
|
| Shrink-fitting and dowel welding in mortise and tenon structural wood joints |
|
|
| Eric Mougel 1Carlos Segovia 1 |
|
|
| (01/01/2011) |
|
|
|
| Shrink-fitting, a common bonding technique in metal assemblies, was used for mortise and tenon wood joints. The joints had considerable strength. Shrink-fitting yielded joint strengths comparable to those obtained by using several welded dowels. Increasing the number of welded dowels, however, produced joints of higher strength than those bonded just by shrink-fitting. Combining in the same joint both dowel welding and shrink-fitting yielded joint strengths higher than those obtained by the individual techniques alone, and at the same time allowing decreasing the number of welded dowels needed. |
|
|
|
|
|
|
|
|
|
|
|
| 1 : | Laboratoire d'Etude et Recherche sur le Matériau Bois (LERMAB) |
|
|
|
INRA : UMR1093 – Université Henri Poincaré - Nancy I – AgroParisTech |
|
|
| 2 : | Centre de recherche en automatique de Nancy (CRAN) |
|
|
|
CNRS : UMR7039 – Université Henri Poincaré - Nancy I – Institut National Polytechnique de Lorraine (INPL) |
|
|
|
|
|
|
|
|
|
| SYMPA |
|
|
|
|
| Domaine | : | Informatique/Recherche d'information |
|
|
| Shrink-fitting – wood welding – mortise and tenon joint – dowel welding – joint strength |
|
|
|
| Liste des fichiers attachés à ce document : | |||||
|
|||||
|
|
|
| hal-00541133, version 1 | |
| http://hal.archives-ouvertes.fr/hal-00541133 | |
| oai:hal.archives-ouvertes.fr:hal-00541133 | |
| Contributeur : André Thomas | |
| Soumis le : Jeudi 2 Décembre 2010, 16:34:10 | |
| Dernière modification le : Vendredi 3 Décembre 2010, 19:59:24 | |
